FoodSaver VS9000, Руководство пользователя

Страница: 10 / 24

8
Using your FoodSaver ® GameSaver™ continued
Tips on sealing & vacuuming a bag
Make sure you've securely locked the FoodSaver
®
appliance lid. When making a bag from a roll,
place bag material on the sealing strip, close
and lock the lid.
Prevent moisture or liquid from being pulled into
the Vacuum Channel or trapped in the seal. For
very moist or wet foods either use Seal only,
or pre-freeze for 1-2 hours before vacuum
packaging. Alternatively
place a folded paper
towel between food and end of bag to absorb
excess liquids. Just be sure to leave at least
7.5cm between food and end of bag so that
bag seals properly with paper towel inside.
Make sure you give FoodSaver
®
appliance time
to cool down. The FoodSaver
®
GameSaver™ is
able to create up to 50 consecutive vacuum
seals. Under very heavy usage, appliance will
not operate to prevent overheating. If it does,
wait 20 minutes to allow appliance to cool
off.
Vacuum packaging in bulk
To package a large number of bags at one
time, it is recommended to:
- create bag
- place foods in bag
- vacuum & seal
- repeat
Following this process will prevent the
appliance from overheating.
Make sure you've securely locked the
FoodSaver
® appliance lid. 'When vacuuming
and sealing a bag or container ensure the lid
has been fully closed and lid has locked into
place.
Check for wrinkles in the bag along the Sealing
Strip. Wrinkles in seal may cause leakage and
allow air to come back into bag. Check for
wrinkles in bag along Sealing Strip before
closing lid and vacuum packaging. If you find
wrinkles after sealing bag, simply cut bag
open and vacuum seal again.
If the motor runs for more than 2 minutes
without stopping, consider the following:
- adjust the bag and try again.
- if you are making an initial seal on a piece
of bag material with two open ends, make
sure the bag is placed on the sealing strip.
- if you are vacuum packaging with a bag,
make sure the open end is placed down
inside the vacuum channel.
- ensure the accessory hose is not attached.