GB
8
Note: Charge the speaker for at least 2.5 hours before
first use.
Switching on/off
To switch on
the speaker, set the on/off switch (7) to „
ON
“.
To switch off
the speaker, set the On/Off switch (7) to „
OFF
“.
LED illumination
Limboso is equipped with an LED illumination that starts to glow
when switched on. By pressing and holding the multifunction
button (1), the illumination can be switched off and on.
Pairing with a Bluetooth
®
source
The speaker must be connected to a Bluetooth® device before it
can be used for wireless music streaming.
1.
Switch on the loudspeaker by setting the On/Off switch (7)
to „
ON
“. The speaker automatically switches to pairing mode.
2.
Search for Bluetooth
®
audio devices with your Bluetooth
®
device from which audio data is to be played.
3.
The searching Bluetooth
®
indicates that it has found the
speaker „
Limboso
“.
4.
Confirm the pairing with „
Limboso
“. Enter „
0000
“ if you
are asked for a code.
When using a Bluetooth
®
device without a display, switch it to
pairing mode and wait a few seconds for the connection with the
speaker to be established.
NOTE: If the connection is lost or the transmitter is
disconnected for a short time, turn the speaker off and on
again. After switching off and on again, both devices connect
automatically.
