Fontaine 3000 series, Руководство по установке

Страница: 5 / 24

Front
Back
Top
Figure B
Fontaine
®
Fifth Wheel Handbook
5
9. All mounting holes shall be drilled, not burned. All
edges shall be ground smooth to prevent point loading.
10. When required to clear obstructions, cutouts in the
mounting angles shall be smooth and straight with a
minimum radius of 1" (25.4mm). No sharp corners
are permitted and all edges shall be ground smooth. A
minimum of two bolts is recommended beyond a
cutout.
11. Care must be taken to avoid interference or contact
between the fifth wheel and any other component
when rear of fifth wheel is depressed. In order to
prevent this, it is recommended that a stop be used.
The stop should be positioned so that contact is made
with the fifth wheel mounting plate.
12. Do not restrict normal rock of fifth wheel. This could
create a hazardous operating condition.
13. All fifth wheels subjected to weather abuse must be
thoroughly cleaned, inspected, and lubricated prior to
installation.
14. Fifth Wheels should be mounted in the proper
orientation relative to the tractor (See Figure B ).
Do not
mount the fifth wheel upside down or
backwards.
Figure A
STRAIGHT EDGE STRAIGHT EDGE
OUTBOARD
ANGLE
OUTBOARD
ANGLE
OUTBOARD
ANGLE
GAP AT THE
MIDPOINT OF THE
TRUCk FRAME FLANGE
SHOULD BE LESS
THAN .030"
GAP AT THE MIDPOINT OF THE OUTBOARD ANGLE
SHOULD BE LESS THAN .030"
TyPICAL TRUCk
FRAME
TyPICAL TRUCk
FRAME