FONESTAR WA-2154D, Инструкция по эксплуатации

Страница: 5 / 8

CONNECTION
- Make the connections with the amplifier and all the audio system components switched off and
disconnected from the mains.
- Connect the required audio sources to inputs INPUT 1 - 3. Then select the required source by pressing the
corresponding switch.
Note : if you have both digital inputs connected (coaxial and optical), you must select the required input with
the INPUT 1 SELECT switch.
- If you wish, connect headphones to the headphone output.
- Check that the general volume and headphone controls are at their minimum.
- Connect the loudspeakers to the low impedance outputs in a series/parallel circuit so that the load
impedance from the loudspeakers is the same as the amplifier output impedance and the power supplied
by the amplifier does not exceed that withstood by the loudspeakers.
- Once the connections have been made according to your needs, connect the equipment to the mains and
switch it on. After use, do not forget to disconnect everything from the mains.
- 5 -
EN