e)
Press the RECORD”button again.
Wait until the LED recording indicator stops flashing and remains lit. The message number will remain
on the display.
d)
Record the message using the microphone, through the audio AUDIO IN input or through both at the
same time
NOTE: the recording will not be heard through the loudspeaker to avoid feedback. The recording can
be heard through the headphone output.
NOTE: adjust the volume of the source connected to the AUDIO IN input to an appropriate level
without distortion. During the recording the signal connected to the audio input can be listened to
through the headphone output.
NOTE: the numbers on the LCD display will countdown when the memeory capacity is lower than 30
seconds.
e)
To finish recording press the CANCEL/END key and wait until “00” flashes on the display.
Pre-listen to messages
Recorded messages can be pre-listened to before being broadcast. Pre-listening is performed through the
microphone’s loudspeaker or through the headphone output if headphones are connected. The messages
are not broadcast through the MIC OUT audio output.
a)
Select the message number.
b)
Press the PREVIEW button.
c)
Playback will stop when the end of the message is reached. It is possible to stop before by pressing
the CANCEL/END button and waiting until “00” appears flashing on the display.
Message playback
When a message is played it is broadcast through the audio output MIC OUT and can be listened to through
the microphone loudspeaker or through the headphone output if headphones are connected.
a)
Select the message number.
b)
To play and broadcast a message press the PLAY button.
If they are activated the chimes will be broadcast.
NOTE: while the chimes are being broadcast “
” will be shown on the display.
Then the recorded message is played.
NOTE: during playback the message number will be shown on the display. If the message number
flashes the message is not recorded.
Playback finishes at the end of the message. It can be stopped before by pressing the CANCEL/END
button.
If the chimes are activated wait for them to be broadcast.
NOTE: while the chimes are being broadcast “
” will be shown on the display.
Message playback can be interrupted at any time to page through the microphone.
a)
Press the TALK button,
Message playback will be interrupted.
The LED TALK button will light up.
b)
Talk through the microphone.
NOTE: the message will not be heard through the loudspeaker to avoid interference. The broadcast
can be listened to through the headphone output.
NOTE: while the microphone is open “
” will be shown on the display.
c)
When paging has finished press the TALK button.
The LED TALK button indicator will switch off.
Message playback will continue.
EN
- 7 -
151110_MCH-221D_Maquetación 1 20/1/16 8:09 Página 7