EN
- 6 -
CONNECTION
- Connect the loudspeakers to the loudspeaker output. Use the low impedance output 4/8 Ω or the low
impedance line output 100 or 70 V, according to the type of loudspeakers to be connected. Do not use
both types of output at the same time.
- If the low impedance output is used, the loudspeakers must be connected in a series/parallel circuit so that
the load impedance of the loudspeakers is the same as the amplifier output impedance and that the power
supplied by the amplifier does not exceed that withstood by the loudspeakers.
- If the 70 or 100 V high impedance line output is used, all the loudspeakers must be connected in parallel
and the sum of the power of all the loudspeakers must not exceed the power supplied by the amplifier.
- Once the connections are made according to your needs, connect the devices to the mains and turn them
on. After use, do not forget to switch off and disconnect the devices from the mains.
Example of connection of preamplifier and two power amplifiers
FS-1240E
in cascade
with loudspeakers connected in 100 V line
FS-1240E-MANUAL-(EN)-20151130_Maquetación 1 30/11/15 17:43 Página 6
