RECEIVER
(mods.
FO-455M
and
FO-456MR
)
1.- Power supply input for the mains adapter provided.
2.-
OUTPUT
: A/V digital output, HDMI connector.
3.- Reset button. Press and hold this button for 5 seconds to restore the transmitter’s IP and MAC addresses
to the factory settings.
4.-
IR IN
: remote control IR receiver connection input. Connect the IR extension cable to be able to change
the transmission channel remotely. This is the only way to change channel using the remote control.
Below the channel ratio is shown depending on the value which appears in the receiver display.
5.- Receiver input, RJ-45 connector.
6.-
CHANNEL
: transmission channel selection button. Press this button several times to select the required
transmission channel.
Note
: if this button is pressed and held for 3 seconds, the device restarts. This restart does not alter the
value of the transmitter’s IP and MAC addresses.
- 5 -
EN
160311_FO-455M_FO-456MR_MANUAL_(EN)_Maquetación 1 14/3/16 8:31 Página 5
