21
(Fig.2)
5.
Change the DIP3 to channel 202 (frequency dip-switch 00000010) as shown on Fig.3.
(Fig.3)
6.
Change “1” of the DIP3 to “ON” position as shown on Fig.4 to setting status (frequency
dip-switch 10000010).
(Fig.4)
7.
Put the battery back into the battery compartment and insert the power key to its
original position, then green LED is ON and the change is completed.
8.
After the change, the new channel is 202. Then make sure that the “1” of DIP3 is set to “OFF”
position as shown on Fig.3 (frequency ID 00000010), or transmitter will not be activated.
9.
Screw and assemble the transmitter bottom casing with transmitter top casing and start the
transmitter again to operate.
10.
To change the setting to another channel, please refer to the Frequency (RF) Channel Table as
below.
※
Functions for Dip-switch DIP3: Top slot “1” for “ON”.
