Appello 4P illustration
This unit including two parts, the GPS device and the Docking station (Base), the GPS device is a GPS
tracker, the Docking station is a remote controller within scope of 10m and also 6380mAh power bank
when put the GPS device on base.
1. Introduction of GPS device and the Docking station
a. The Docking station is the GPS device’s power switch; the effective distance of remote control is
10m. When the GPS device leaves from base out of 10m, the GPS device will work automatically after
80 seconds; and it will be no longer controlled by the base. when it get into the scope of 10m, the
GPS device will go to sleep automatically.(PS: A base can control all GPS which are in the scope of
10m, and those GPS device can’t startup & stop by themselves.)
b. The Docking station with a strong magnet which can hold itself firmly on the metal board;
c. You can put the GPS device on base to charge, when the GPS device run out of the power; you can
put the GPS device on base and use them as a whole for a powerful GPS tracker.
2. The button and LED indicator light (below pictures)
a. Please be caution of the direction of below 5 contacts when put GPS device on base:
b. Put the right side of the GPS device on the base firstly, gently press the left side to combine, the
GPS device will charge automatically and red LED light blinking; stop when done.
c. When press the SOS button, the orange light blinking, then the light will off after flashing 3 minutes
consistently. Flashing 1time/1second is LBS location; flashing 1time/3seconds is GPS tracking. If blue
indicator light flash 1time/1second, it means tracking successfully; flashing 1time/3seconds is sleeping
mode. Pressing the key 3 seconds is SOS alarm.
d. Sliding the switch of the base to control the charge for GPS device. Mini USB port with a white
longer cable connect for charging; white shorter power supply cord can take electricity 5v-1A to
recharge for mobile phone or other electronic devices; The other cables to update firmware through
the USB port.
e.“Reset” button locate on the position of”QC” mark. Slightly pressing this button, until the LED
orange light blinking, upgrades firmware or reset System;
f
．
LED orange light on the base is power indicator, LED green light is charge indicator. Flash 1time/5s
=30% orange light; flash 1time/3s = 20% power remaining; flash 1time/1s=10% power remaining; off=
0% the green light on when charging and stop when done. The LED red light of the base is power
indicator. The red light flash 1time/5s means left 30% power; the red light flash 1time/3s means left
20% power, the red light keeps on to off means left 0% power. The LED green light would on when
