26
[Enabled], it allows CPU to go to C states when it’s not 100% utilized.
The optional settings: [Disabled]; [Enabled].
Turbo Mode
Use this item to enable or disable Turbo Mode (requires Intel Speed Step or Intel
Speed Shift to be available and enabled.)
The optional settings: [Disabled]; [Enabled].
*
Note
: This item might not be available depending on configuration.
SATA Configuration
Press [Enter] to make settings for the following sub-items:
SATA Configuration
SATA Controller(s)
Use this item to enable or disable SATA Device.
The optional settings: [Enabled]; [Disabled].
When set as [Enabled], the following items shall appear:
SATA Mode Selection
This item determines how SATA controller(s) operate.
The optional settings: [AHCI]; [RAID].
SATA1/SATA2/SATA3/SATA4/SATA5/SATA6/SATA7/SATA8
Port
Use this item to enable or disable SATA Port.
The optional settings: [Disabled]; [Enabled].
Hot Plug
Use this item to designate this port as Hot Pluggable.
The optional settings: [Disabled]; [Enabled].
*
Note
: JIPC-Q37MF supports 6* SATA; JIPC-C24MF supports 8* SATA.
PCH-FW Configuration
Press [Enter] to view Management Engine Technology Parameters and make
settings in the following sub-item:
ME Firmware Version
ME Firmware Mode
Firmware Update Configuration
Press [Enter] to make settings for ‘
Me FW Image Re-Flash
’.
Me FW Image Re-Flash
Use this item to enable or disable Me FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
*
Note
: In the case that user needs to update Me firmware, user should set ‘Me
FW Image Re-Flash’ as [Enabled], save the settings and exit. The system will
turn off and reboot after 4 seconds. If the user goes to BIOS screen again will find
this item is set again as [Disabled], but user can still re-flash to update firmware
next time.
AMT Configuration
Use this item to configure Intel(R) Active Management Technology Parameters.
Press [Enter] to make settings for the following sub-items:
AMT Support
Use this item to enable or disable AMT support. When disabled AMT BIOS
