Additional Guide | T.E.C. PACK for Shimano Steps E8000 Version 1
EN-13
5.
Installing a bottle holder
To install a bottle holder, you need the Smart Rack. Follow these steps:
1. Fix the bottle holder with the
two bottle holder screws on
the Smart Rack. Tighten the
M5 screws with 4 - 5 Nm.
for 1. Mount the bottle holder
6.
Smart Rack
6.1
Fix the Smart Rack
1. Place the Smart Rack with the
mounted bottle holder on the
Bone Rail.
for 1. Place the Smart Rack on the Bone Rail
4.
Charger
Please refer to chapter 8 of the "Owner's Manual Shimano
E8000" for information on the safety and function of the
charger. Error messages that may occur on the charger can
be found in chapter 9.3 of the manual.
4.1
Charging the battery
Connect the power cable to the battery charger.
1. Connect the charging cable to the charging socket on the battery (it
clicks into place).
2. Plug the mains connector into a socket. The green LED on the charger
flashes rapidly at a constant rate
. The button on the crossbar
lights up blue.
3. The charger switches off once the battery is fully charged. The green
LED on the charger is continually on . The button on the crossbar
lights up blue.
If the battery now stays on the charger, it regularly checks
whether the battery is still fully charged. The LED on the
charger then starts to flash green again. After checking and
ascertaining that the battery is full, the charger switches
back to “light continually”.
4. Remove the power cable from the socket after completing the charging
process.
5. Remove the charging cable from the battery charging socket on the
battery.
