Focus FS-T1001, Руководство пользователя

Страница: 33 / 52

FS-T1001 Menus
FS-T1001 Media Recorder - 21
•
HDD
Use this mode to set the FS-T1001 to USB device mode.
This permits connecting the unit to a computer via USB and
mounting the inserted SxS card to the computer's desktop.
CONTROL
•
NORMAL
– Use this setting to control the FS-T1001 from the
unit's front panel. Ancillary record trigger data in the HD-SDI
input stream is ignored.
•
EX TRIG
- Use this setting to control the FS-T1001 by
receiving record and stop triggers from ancillary data in the
HD-SDI input stream (assumes a source that supports ancillary
data is being utilized).
•
EXT TC
control mode triggers the FS-T1001 from the camera
controls (using timecode breaks).
The camera must support REC RUN or REGEN timecode and
be set to that mode. In addition, it may also require media to be
inserted and recorded to on the camera: consult the camera’s
user guide for further information. NOTE: When this mode is
being used, before connecting FS-T1001 to the camera, make
sure the camera is set to REC-RUN mode and not recording.
REC MODE
•
NORMAL
- In normal record mode, FS-T1001 begins recording
immediately when triggered.
•
RETRO CACHE
- In retro cache record mode, the FS-T1001 is
constantly in record mode, caching video to flash RAM in a
loop on the unit for a predetermined amount of time (set in one
second intervals, up to 10 seconds, in the setup menu). Once
record is triggered (in either normal or external control mode),
the cached content is added to the beginning of the recording.
REC FORMAT
•
HQ MODE
- Sets the record bit rate to 35Mb/s (MP@HL)
record mode in the XDCAM EX format.
HD SDI Input for HQ Mode
The HD-SDI input signal can be 1920x1080, 1440x1080 or
1280x720 in HQ mode. See the supported frame rates in the
specification section of this manual.