Except where otherwise stated, all rights, including copyright in the text, images and layout of this booklet is owned by Focal Point Fires
plc.You are not permitted to copy or adapt any of the content without the prior written permission of Focal Point Fires plc.
IMPORTANT NOTES:
DO NOT
-
use this appliance immediately below a fixed socket outlet.
-
use this appliance in the immediate vicinity of a bath, shower, swimming pool or other area where water or moisture could
present a hazard.
-
mount on a ceiling or floor.
- recess any part of the appliance into the wall.
-
site in a position where curtains or drapes could cover the appliance.
-
site in a position where other soft materials could cover the appliance e.g. below a coat rack.
-
site behind an opening door where mechanical impact/damage could occur.
-
site where the supply cable would become a trip hazard.
-
sit, stand or forcefully pull on the appliance.
-
obstruct, cover or force items into the openings.
-
use the heater to dry clothes.
-
site/use in an outdoor location(s).
-
run the supply cable under carpets.
- use if the supply cord/plug shows signs of damage.
CAUTION: This appliance must not be used in conjunction with any timer, programmer or thermal control, or any other
device that will switch on the appliance automatically, as a fire risk may occur if the heaters are accidentally covered or
displaced.
Do not allow the heater to be covered as this may cause overheating. The appliance must not be placed near curtains or similar material.
A clearance space of at least one metre should be allowed in front of the appliance.
The electrical socket that the appliance uses MUST be easily accessible. Do not route the supply cord directly in front of
the heater unit. If the cord is damaged, it must be replaced by a service agent or competent person.
INSTALLATION REQUIREMENTS:
The appliance is supplied with a pre-wired three pin plug, (13Amp fuse rated), and 2 metres of electrical cable. It is therefore necessary for
a suitable electrical socket to be located within this distance and be easily accessible.
This appliance is designed to be wall-hung, using the wall fixtures/fixings provided. DO NOT recess any part of appliance
into the wall. If you are unsure or feel incapable of installation, seek professional advice/help
It is recommended that the installation should be protected by a 30mA RCD, (Residual Circuit Device), either via the existing main con-
sumer unit if fitted, or by a dedicated device as part of this installation.
1
Section
1.0
2.0
3.0
4.0
4.1
5.0
6.0
Contents
Important Notes
Installation Requirements
Appliance Data
Unpacking the Appliance
Component Checklist
Appliance Assembly
Site Requirements
Page No.
1
1
1
2
2
2
2
Section
7.0
8.0
8.1
9.0
10.0
11.0
12.0
Contents
Fixing the Appliance
Operating the Appliance
Safety Cut-Out System
Maintenance/Servicing
Cleaning
Spares
Product Views & Dimensions
Page No.
3
4
4
5
5
5
6
1.0
2.0
IMPORTANT
THIS APPLIANCE MUST BE EARTHED
The manufacturer declines all liabilities for injury to persons, or damage to property, resulting from
failure to observe this regulation, and/or failure to follow or observe these instructions.
APPLIANCE DATA:
Supply Voltage:
230/240V ac, 50Hz
Fuse Rating:
13 Amp
Heating Elements:
2 x 900W/2 x1000W
Lighting:
2 x 60W Clear “bayonet connection” bulbs
3.0
This appliance conforms to European Directive:
73/23/EEC Low Voltage (Safety), and CE marking Directive.
© 2007 Focal Point Fires plc.
