FocalPoint ATHERSTONE BRICK ELECTRIC SUITE, Инструкция по установке и эксплуатации

Страница: 8 / 10

2021
Setting the Heat Timer
Selecting the Day
Set TIMER ON Time
Set TIMER OFF Time
Safety Cutout System
ALWAYS DISCONNECT THE APPLIANCE FROM THE MAINS SUPPLY OUTLET
SOCKET BEFORE UNDERTAKING ANY CLEANING OR MAINTENANCE!
Press the “
TIMER SET
” button on the remote control, the time cycle number will flash. Use the “
+
” and “
-
” buttons to cycle
through the different timer cycles from 1 to 10 and press the “ TIMER SET ” button to confirm. A small black triangle will flash
below one day of the week,indicating that the day of the week need to be determined.
Press the “
CLEAR
” button can cancel the set time conveniently.
STEP 1: Press the up or down buttons on the remote control to choose the set day between“
SUN
” to “
SAT
”, the default day is
“ SUN ”. Press the “ + ” button to confirm the set day. Press the “ TIMER SET ” button to confirm.
STEP 2:
Repeat
STEP 1
to add other days to the chosen timer cycle, or press the “
-
” button to delete the set day. Press the
“
TIMER SET
” button to confirm.
The “
ON
” symbol will illuminate on the LCD display to indicate that the Timer ON will need to be set.
STEP 1
: Press the “
+
” or “
-
” button to set the hour setting for Timer ON and press the “
TIMER SET
” button to confirm.
STEP 2
: Press the “+” or “
-
” button to set the minute setting for Timer ON and press the “
TIMER SET
” button to confirm.
The “
ON
” symbol with turn off and the “
OFF
” symbol will illuminate.
The “
OFF
” symbol will illuminate on the digital display to indicate that the timer OFF will need to be set.
STEP 1
: Press the “
+
” or “
-
” button to set the hour setting for Timer OFF and press the “
TIMER SET
” button to confirm.
STEP 2
: Press the “
+
” or “-” button to set the minute setting for Timer OFF and press the “
TIMER SET
” button to confirm.
CAUTION: This product has a self-resetting overheat protection device. In the event that the heater stops working as a
result of overheating, the fan kept working all the time, take the following immediate steps , switch the electricity off at the
socket and remove the plug. Remove any objects that are covering the product.
CAUTION: Do not touch the heater as it will be hot. Set the heater switches to OFF and leave the heater to cool down fully.
Once completely cool, reconnect the heater and switch it on. Do not open this product , There are no user-serviceable parts.
Open Window/Door detection
When this function is enabled , if the ambient temperature is lowered due to the opening of th doors or windows, indicator
light on “ HEAT ” button on the appliance will blink to remind the user to close the window/door. If there is no resphonse, the
system will automatically stop heating.The heater can be turned back on by pessing " HEAT I " or " HEAT II ".
NOTE:
Press the window button once to active the window monitor, Press it again to switch the window monitor off.
1. Remove the plug from the wall socket.
2. Remove the 2 screws holding the fuel bed into position.
3. Remove the 4 screws that hold the flame effect into position.
4. Remove the LED strip and unplug the small connector.
5. Replace with a new LED strip and reassemble the appliance.
2 screws
4 screws