Cables and connections
For best results with your speakers, we recommend you include the use of Focal cables.
Alternatively, other high quality cable can be used, if sufficient section thickness is available
(minimum thickness = 1mm
2
). This is particularly important for long lengths of cable to
ensure a strong efficient signal is maintained. Always ensure the polarity is respected, (+ is
connected to + and - is connected to -). Maintain correct connections, from principal source
radio / amplifier (left / right / front and rear), and crossover to speakers (tweeter to tweeter, mid
to mid, woofer to woofer), is always observed.
Connections
Fitting the tweeter
There are two mounting possibilities available: surface or flush mount. The tweeter arrives
supplied in its flush-mounting pod. Very carefully, remove the grille, by gently prizing it off
(using a paper clip will help). Don’t forget to put the grille back, it has a great impact on the
tweeter frequency response.
Surface mounting:
choose the angle that best suits your installation (10° or 30°) and mount
the pod firmly using the screws supplied. Feed the wire through the hole in the pod and refit
the tweeter and grille in place.
Flush mounting:
cut a neat 45mm diameter hole
in the panel where you want to place the tweeter.
Then with the metal mounting strip held from
behind (ensuring the ends are pointing towards
the hole), insert the screw through the flush-mount
pod from the front and tighten the two parts
together. Feed the wire through the hole in the pod
and refit the tweeter and grille in place.
polyglass 165 V 30
U s e r
M a n u a l
3
Right Output
Left Output
Woofer
Tweeter
Woofer
Tweeter
Input
Input
Grille
Unlocking tool
Tweeter
Pod
Mounting strip
130.com.ua
Autogood products Internet store “130”
