4
•
If you have six input wires from the source deck plug them into inputs 1+2, 3+4, 5+6.
Set INPUT switch to 6.
•
Put your woofer/tweeters on channel 1+2, 3+4.
Set 1+2, 3+4 switch to HP.
Adjust 1+2, 3+4 HP frequency to 75 Hz.
•
One 4ohm subwoofer bridged mono is wired to channel 5+ and channel 6-.
*
Do NOT use a 2ohm subwoofer.
Set channel 5+6 switch to LP/BP.
Set channel 5+6 MODE switch to SUB.
Plug in the remote sub control.
Adjust the 5+6 LP frequency to 75 Hz.
For a sealed box adjust the 5+6 HP frequency to 20 Hz.
For a vented box adjust the 5+6 HP frequency 5 Hz lower than the port tune frequency.
REMOTE SUB CONTROL
+
–
SUBWOOFER
75Hz
6
HP
75Hz
20Hz
SUB
LP/BP
75Hz
HP
C3
(5 CHANNEL WITH BRIDGED SUBWOOFER)
RADIO
XOVER
XOVER
XOVER
XOVER
TRIAMP A SUBWOOFER, WOOFER, AND TWEETER
(SEE GRAPHIC C4 ON PG 5)
•
Connect the source deck front channel wires into inputs 1+2.
Set INPUTS switch to 1+2.
•
Connect your tweeters to channels 1+2.
Set 1+2 switch to HP.
Adjust 1+2 HP frequency to the tweeter manufactures recommendation. 4 kHz is a good starting point.
•
Connect your woofers to channels 3+4.
Set channel 3+4 switch to LP/BP.
Set channel 3+4 switch to BP.
Adjust the 3+4 LP frequency to the manufactures recommendation. 4 kHz is a good starting point.
Adjust 3+4 HP frequency to 75 Hz.
•
If you have two subwoofers connect one to channel 5 and one to channel 6.
•
If you have one 4ohm subwoofer connect it to channel 5+ and channel 6-.
Do NOT use a 2ohm subwoofer.
•
Set channel 5+6 switch to LP/BP.
Set channel 5+6 MODE switch to SUB.
Plug in the remote sub control.
Adjust the 5+6 LP frequency to 75 Hz.
For a sealed box adjust the 5+6 HP frequency to 20 Hz.
For a vented box adjust the 5+6 HP frequency 5 Hz lower than the port tune frequency.
