I
SI
Check the wall does not have any wiring or pipe work behind where you intend to drill. Consult a qualified
person if you are not sure.
3. Drill a 6mm hole in the two marked positions approximately 35mm deep into the wall.
4. Insert the wall plugs into the wall.
Note: If fitting the product to plaster board with a cavity behind then appropriate wall fixings (not supplied) will be
required. If in doubt, please seek advice from a suitably qualified tradesman.
S. Route the supply cord to exit the same side of the suite where the mains socket outlet is located. Check the supply cord is
not trapped under the suite such that it may cause it to be damaged.
6. Then secure the suite with the 4 x 30mm screws (supplied).
8.
5. 6.
7.
4.
----1.
�
-:,,,
:::-9
r-
----3.
--------2.
1.
Mantel
5. Heat button
2. White Pebbles
6. Flame button
3. LED display
7. Power button
4. Remote
8. On/Off switch
control
1. LCD display
2. Power button
1.
3. Date Time button
4. Timer Set button
5. Up button
6. + button
2.
3.
7. Clear button
4.
5.
8. Timer ON/ OFF button
7.
9. - button
6.
9.
10. Auto button
10.
11.
11 . Down button
13.
12.
15.
12. Flame button
14.
13. Window button
8.
14. Heat I button
15. Heat 11 button
NOTE: Before attempting any operation with the remote control, press and slide the battery door (on the back of remote)
open and insert two AM batteries, checking that the+ and - sides of the battery match inside the battery compartment,
close the battery door.
Do not press the remote control buttons more than once within two seconds for correct operation. Please wait for the receiver
to respond to the transmitter.
(D
© 2021 Focal Point Fires Ltd.
