3
©
2018 Focal Point Fires plc.
2.0 INSTALLATION REQUIREMENTS
3.0 APPLIANCE DATA
Supply Voltage and rating power : 220-240V AC 50Hz, 1500 - 1800W
Fuse Rating :
13 Amp
Heating Elements :
1500 - 1800W
Lighting :
LED Light Strip
Location :
Indoor use only
Supply plug/cord : BS1363/1.8 metres length
This product is only suitable for well insulated spaces or occasional use. The appliance is supplied with a pre-wired three pin BS1363
plug (13Amp fuse rated) and 1.8 metres of electrical flex. It is therefore necessary for a suitable electrical socket to be located within
this distance of the appliance and be easily accessible. The stove may be installed on a combustible or non-combustible floor, however
the heater outlet is underneath the stove and certain types of floor covering may be affected by the heat produced by the stove. The
ability of the floor covering to withstand the heat produced by the stove should be ascertained before proceeding with the installation
of the stove. If in doubt then the stove should be mounted on a non-combustible hearth or plinth which extends at least 150mm in front
of the stove.This appliance should be positioned on a firm level surface. If the stove is to be sited in a fire surround then the suitabili-
ty of the surround for use with electrical heaters should be established with the fire surround manufacturer.If fitted into an open draught
fireplace, it is advisable to block off the chimney to reduce the risk of draught through the stove which may cause the safety cut out sys-
tem in the fan heater to operate.
• DO NOT run the mains cable under carpets, rugs etc.
• DO NOT cover or obstruct the heater in any way. Overheating will result if it is acci-
dentally covered.
• Never immerse the product in water or any other liquids.
• DO NOT use the appliance outdoors.
• Before cleaning the appliance, ensure it is unplugged from the power and that it is com-
pletely cool.
• DO NOT clean the appliance with abrasive chemicals.
• Never use accessories that are not recommended or supplied by the manufacturer. It
could cause danger to the user or damage to the appliance.
• DO NOT insert or allow foreign objects to enter the inlet or outlet vents as this may
result in electric shock, fire or damage to the appliance.
• DO NOT install the fire using an extension cord.
• Unplug from the mains supply if the appliance is not to be used for long periods.
1.0 IMPORTANT NOTES - CONTINUED
GB IE
Model
EF09-19
Item
Symbol
Value
Unit
Item
Unit
Heat output
Types of heat input, for electric storage local
space heaters only
Nominal
heat output
Pnom
1.6
KW
Manual heat charge control with
integrated thermostat
N/A
Minimum heat
output
(indicative)
Pmin
N/A
KW
Manual heat charge control with
room and/or outdoor temperature
feedback
N/A
Maximum
continuous heat
output
Pmax, c
1.6
KW
Electronic heat charge control with
room and/or outdoor temperature
feedback
N/A
Auxiliary electricity consumption
Fan assisted heat output
N/A
At nominal
heat output
elmax
0.0
KW
Type of heat output/room temperature control
At minimum
heat output
elmin
0.0
KW
Single stage heat output and no
room temperature control
No
In standby mode
elSB
0.0
KW
Two or more manual stages no tem-
perature control
No
With mechanical thermostat room
temperature control
No
With electronic room temperature
control
No
Electronic room temperature con-
trol plus day timer
No
Electronic room temperature con-
trol plus week timer
Yes
