4.3 ELECTRICAL CONNECTION
GB IE
© 2018 Focal Point Fires plc.
5
There are no internal user serviceable parts.
Check regularly for security of wall fixings as appropriate. Also check security of supply cable and connections. If the supply cable
becomes damaged, it must be replaced by a service agent or competent person, such as a qualified electrician.
This appliance is supplied with a BS1363 3 pin plug fitted with a 13 Amp fuse. Should
the fuse require replacing, it must be replaced with a fuse rated at 13 Amp and
approved to BS1362. In the event of the mains plug being removed/ replaced for any
reason, please note : IMPORTANT: The wires in the mains lead are coloured in
accordance with the following code:
Blue - Neutral
Brown - Live
Green/ Yellow - Earth
As the colours of the wires in the mains lead of this appliance may not correspond
with the colour markings identifying the terminals in your plug, proceed as follows.
The blue wire must be connected to the terminal marked with an N or coloured
black. The brown wire must be connected to the terminal marked with an L or coloured red. The green/yellow wire must be
connected to the earth terminal which is marked with an E or with the earth symbol. WARNING: Never connect live or
neutral wires to the earth terminal of the plug.
NOTE: If a moulded plug is fitted and has to be removed take great care in disposing of the plug and severed cable, it must be
destroyed to prevent engaging into a socket.
Excluding fuses, use only genuine manufacturers spare parts available from your supplier.
4.4 GAS CONNECTION
The inlet to the cooker is a 8mm pipe.
Ensure that all pipe work is of the correct rating for both size and temperature.
Please check that all gas connection are good after installation.
Burner aeration: All burners have fixed aeration and no adjustment is possible.
Pressure setting:
I3+
LPG at 37 mbar for G31, 28 - 30mbar for G30.
Pressure test point: Use the oven injector
Hob: Turn the control knob to the FULL ON position, wait a second before pressing the ignition switch or holding a lighted
match or taper to the burner.
4.5 USING THE HOB
Ignition: Push in and turn the selected control knob anticlockwise to the ‘full on’ position and press the ignition switch
at the same time, or hold a lighted match or taper to the burner, until the burner lights. It is necessary to hold the con-
trol knob in for up to ten seconds to establish the safety device. Turn the control knob to the required setting.Adjust the burn-
er flame so that it does not extend over the pan base.
To turn off, push in the control knob and turn clockwise until the dot on the control knob is below the dot on the facia panel.
To simmer: The simmer position is marked by the small flame symbol.
Once lit turn the selected control knob anticlockwise past the large flame symbol (FULL ON) to the small flame symbol.
You may hear a slight popping noise when the hob burners are operating and this is quite normal, but if anything about the cook-
er appears unusual, such as change in flame appearance, or the operation of controls - seek expert advice.
