4
Original condition
Telephone default settings
Password
Call melody
Call volume
Receiver volume
Microphone sensitivity
0000
3
5
4
4
The default settings can be restored at any time via the programming function. This will not
however, change the new password.
Assem bly and Installation
Wall mounting
Attach the mountings to the telephone using two screws for each. Use the M5 x 8 mm countersunk
screws supplied. Fasten the telephone with four screws (up to Ø 8 mm in diameter) to the wall.
Serial port connection
Take off the key touchpad together with the handset.
Connect the positive battery connector (red cable) to clamp 9.
Solar panel or voltage supply connection
Push the solar panel cable or DC voltage supply cable through a cable fitting and put the end of
the cable onto clamp 5 and 6 (Note: Observe polarity). Only use a cable with a cladding diameter
between 5 mm to 9 mm, otherwise the protection rating of IP 66 is not guaranteed.
SIM cards
Please insert the SIM card necessary for operation into one of the SIM card holders. If operating
with two SIM cards, please insert both SIM cards into the SIM card holders. The SIM cards must
have their PIN request deactivated.
Plug the flat ribbon cable with connector onto the pin header of the touchpad panel.
Screw on touchpad panel with the four screws.
Red cable
Battery
Connector clamps
Serial port
Solar panel
or DC voltage
supply
