FCC Statement:
This device complies with Part 15
of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference. (2) This device must accept any
interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to
comply with the limits
for a Class B digital
device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection
against
harmful
interference
in
a
residential
installation.
This
equipment
generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee
that
interference
will
not
occur
in
a
particular
installation.
If
this
equipment
does
cause harmful interference to radio or television reception, which can be determined by turning
the
equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the
interference
by
one
or
more of the following measures:
---Reorient or relocate
the receiving antenna.
---Increase the separation between
the equipment and receiver.
---Connect the equipment into an outlet on a circuit different from that to
which the receiver is
connected.
---Consult the dealer or an experienced radio/TV technician for help.
WARNING:
Changes
or
modifications
not
expressly
approved
by
the
party
responsible
for
compliance could void the user's
authority to operate the equipment.
LABEL OF THE END PRODUCT:
The final end product must be labelled in a visible area with the following "Contains TX FCC ID:
2AATL-6222D-UUB". If the size of the end product is smaller than 8x10cm, then additional FCC
part 15.19 statement is required to be available in the users manual: This device complies with
Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device
may not cause harmful interference, and (2) this
device must accept any interference received,
including interference that
may cause undesired operation.
RF Exposure
This device has been evaluated and shown compliant
with the FCC RF Exposure limits under
fixed
exposure
conditions
(antennas
are
greater
than
20cm
from
a
person's
body)
when
installed in certain specific OEM configurations.
This
modular
complies
with
FCC
RF
radiation
exposure
limits
set
forth
for
an
uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. Due to missing shielding the
module is strictly limited to integration by
the Grantee himself or his dedicated
OEM integrator under control of
the Grantee. However,
the OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with
this module installed.
FN-LINK TECHNOLOGY LIMITED
19
Proprietary & Confidential Information
