Frequency Offset: + /-75KHz
Output Impedance: 50 Europe
Harmonic radiation: <-55dbc
Pre-emphasis delay: 50us;;
Separation: 40dB;
Input Level:-13dBV;
Applicable to the microphone: Electret condenser
microphone
Machine Size: 128mm (L) × 93mm (W) × 55mm (H).
Operation instructions
1. Operation steps: installing an antenna---->>>
to connect the power ---->>>to connect audio
source---->>> to connect the microphone
2. Press the power button to boot into normal
working condition.
AS the step of the bottom:
In the back of the transmitter, the antenna
interface (ANT) as a BNC interface, therefore, the
antenna interface should also be as BNC. External
power adapter output voltage DC10 ~ 14V should be
within the range of maximum output current should
be in 2A above. As shown, the power adapter DC plug
connected to the transmitter back "DC12V" on top
of the power socket (Note the polarity is correct,
he is outside the negative)
As shown above, for connecting external sound
source audio lines connected to "AUDIO" interface.
Should use more cable shielding performance audio
cable, 3.5mm plug.
Connect the microphone
Connected to the "MIC" jack. And audio cable,
like a good selection of shielding wires, plugs
for 3.5mm. (Note: The microphone for the
microphone type is Electret condenser microphone.
Boot
After all the preparation work was ready, the
power adapter open, the transmitter is in standby
mode the screen displays "OFF":
Click on the front panel , The transmitter
will enter the normal working state, and then,
through the "+" or "-" It's two buttons to adjust
