Installation manual US01B.M8 / US04B.M8
17.02.2017
7
4
Installation
4.1
Preparation
The sensors are defined as “partly completed machinery” according to the Directives
2006/42/EC, article 2. In order to assure a proper functionality of the parts and
guarantee the essential health and safety requirements of operators working with it, the
following conditions for the assembly must be met:
4.2
General safety information
The Material Sensors may not be stressed over the specification
limits neither during assembly nor operation.
The attachment points for the Sensors on the machine frame must
be properly designed. The used mounting screws must be of the right
size.
For correct installation and operation, follow the electrical wiring
diagram and instructions in this manual.
4.3
Electrical connections
The sensor will be mounted with two M4 screws to a bracket. The bracket itself is fixed
to the location rail or to the flange of the steering frame or linear actuator. The bracket
varies depending on system configuration (steering frame size, manual or motorized
sensor adjustment, etc.). It is not part of supply and must be ordered separately.
If the sensor is used with an integrated web guide controller within an FMS steering
frame FMS-webMASTER, the sensor is connected with a cable 4x0.14mm
2
of the
respective length.
Figure 2: Pin assignment Pin_Assignment_Sensorkabel_Farben_Stecker.ai