FMS 1400MM T-28 trojan v4, Руководство по эксплуатации

Страница: 6 / 16

fig8
6
Install the battery
fig9
Gear
Gear
1. Lower the throttle and throttle trim to the lowest setting. Power on the Transmitter, then wait 4 seconds. It
is recommended to apply hook and loop tape to the bottom of your battery.
2. Install the fully charged battery in the battery compartment as shown. See the Adjusting the Center of
Gravity instructions for more information.
Attach the aileron servo leads to the previously installed "Y" harness. Elevator servo lead goes to elevator
channel of your receiver. The rudder servo goes to the rudder channel. Attach the ESC connector to the
throttle channel of the receiver. Connect the LED to any spare channel of your receiver. If using just a 6
channel receiver you can attach a "Y" harness to any of the channels and plug in the LED lead.The LED to
any spare channel. Tuck the wire leads into the recessed cavity at the rear end of the battery hatch.
fig7
4.
Turn over the fuselage so the bottom faces up and feed the connector wires through the hole in the
fuselage. Secure the wing in place using 4 wing screws.
Flap
HKM3.0*65mm
ESC
BATT
RX