www.fmiproducts.com
123673-01B
2
Figure 4 - Installing Mantel Base
Figure 1 - Installing Header
Figure 3 - Installing Top
Header #4
Right Leg
Assembly #2
Left Leg
Assembly #3
Left Leg
Assembly
#3
1¼'' Screws
1¼'' Screws
1¼'' Screws
Header
Assembly
Block
Base #1
Flush
Assembly
Blocks
Mantel Top #5
ASSEMBLING MANTEL
IMPORTANT: More than one person is required
to lift assembled mantel. Lift mantel by leg
assemblies. Lifting by header or mantel top
could damage mantel.
Use the following illustrations to assemble mantel. Use only
screws provided.
Right Leg
Assembly
#2
IMPORTANT: Make sure heat reflector strip is flush against
header and spacers are on bottom side. Heat strip should
NOT be flush with leg side but should have 1" clearance on
both ends
.
Figure 2 - Installing Heat Reflector Strip
Header #4
Heat Reflector
Strip #6
1¼'' Screws
IMPORTANT:
Align mantel top left to right before installing.
Back of mantel leg must be flush with back of mantel top
before installation.
IMPORTANT:
Align mantel left to right on base before installing.
Mantel legs must be flush with back of mantel base before
installation. Use a tape measure to insure accuracy.
