www.fmiproducts.com
125598-01D
14
Figure 25 - Installing Front Top Log
INSTALLATION
Continued
Figure 26 - Installing Back Top Log and Final Assembly
Figure 26A - Installing Back Top Log, Top View
Front Top Log
(D-024)
Rectangular
Peg
Right Split
Crossover
Log (D-022)
Middle Split Log
Right Split
Crossover
Log (D-022)
Back Top Log (D-062,
D-023 or D029)
Figure 23A - Installing Middle Split Log Rear Top Side
View
Figure 24 - Installing Right Split Crossover Log
Log Notch
Burner Tube
7. Find the front top log (D-024). See Figure 25. The left end
of this log has a square hole that fits over a square peg that
is on the top of the middle split log. The right end of this log
rests behind the knot on the top of the front right log.
8. Find the back top log (LMF36-SC and VFGT24 inch
models: D-062 or LMF42-SC and VFGT30 inch models:
D-023 or LMF48-SC and VTGF36 inch models: D-029).
See Figures 26, and 26A. The left end of this log has a
round hole that fits over the round peg that is on the top
of the back left log. The right end of this log has a rectan
-
gular hole that fits over the rectangular peg on the top of
the right crossover log.
Place lava rock around the base of the burner assembly on
the fireplace floor to simulate an ash bed. Do not place lava
rock or any other material on the burner.
6. Find the right split crossover log (D-022) The bottom of
the log has a rectangular stand off that fits in the slots on
the right side of the front right log and the middle split log.
Place this log as shown in Figure 24.
Right Split Crossover
Log (D-022)
Right Front Log
Square Peg
LAVA ROCK PLACEMENT