OPERATING INSTRUCTIONS
Using the Control Panel: (Locate in Figure 1)
E
D
C B
POWER
A
(ON/OFF)
INDICATOR
Figure 3
Main Switch (Figure 3.A):
Push button down to
“ON” position to start.
Ensure that the control panel is in the
“ON” position, then you can push any button to start the related
function.
Heater Control (Figure 3.B):
1. Press once to activate heat high setting.
2. Press second time to activate heat low setting.
3. Press third time to activate auto heat setting (Note: Please use remote control to set desired temperature).
When the room temperature is lower than the set temperature by less than 6 degree Fahrenheit, Insert will
start only one heater element. This is same as pressing
“Heat Low” button.
When the room temperature is lower than set temperature by 6 degree Fahrenheit or greater, insert will
start both of the fireplace's heating elements. This is same as pressing
“Heat High” button.
When the room temperature is higher than the set temperature, both heating elements will shut
down.
4. Press fourth time to shut heater off.
Simulated Flame Effect (Figure 3.C):
Push button to start simulated flame effect.
Simulated Flame Effect Brightness Control (Figure 3.D & E):
Press to adjust the brightness of the simulated flame effect.
5
