FMC Econat C-15, Руководство пользователя и сертификат гарантии

Страница: 6 / 59

ENGLISH
4
2. SAFETY INSTRUCTIONS
2.1 Electrical Connection
- Check whether your appliance and power cord are damaged before operating your
appliance. If yes, do not plug your heater and contact with authorized technical service or
seller.
- Check whether there is any crack, disjoint, or scratch on the filament (heating tube). If any,
do not plug your heater and contact with authorized technical service or seller.
- Make sure that the primary electrical circuit is appropriate according to your ECONAT
C-15 model:
- Connect your ECONAT C-15 heater to a properly rated circuit. A minimum of 15 amps is
recommended. Many household circuits are rated 15 amps, but if other appliances are on
the same circuit, the breaker may trip. If this is the case, consider moving your heater to a
higher rated circuit, either using a properly rated extension cord (min. 14 AWG.) or by
having the circuit rewired to a higher capability. Ensure that the grounding capability of your
heater's power cord is maintained. Never use a three-prong to two-prong adapter without
securing an additional grounding location.
- When using your ECONAT C-15 heater in kitchens, baths, or exterior application areas
(where approved), use only an approved GFCI (Ground Fault Circuit Interrupter) outlet.
Never locate a heater where it may fall into a bathtub or other water container.
-Try to orient your heater so that the power cord, plug, and/or outlet are not within the direct
heating area.
- Do not allow the power cord to rest on the housing of your heater. Avoid using an
extension cord because the extension cord may overheat and cause a risk of fire. However,
if you have to use an extension cord, the cord shall be a minimum of 14 AWG. And not
rated less than 3000 watts.
- Do not run cord under carpeting. Do not cover the cord with throw rugs, runners, or alike.
Arrange the cord away from the traffic area and where it will not be tripped over.
- Always unplug the heater if it's not being used.
- Unless there is sufficient circuit protection (an integral over current/surge breaker), do not
use multiple cords or extension cords.
- If you are using an outlet strip, it must be rated at 15 amps and include a breaker/reset
function.
- Check whether there is any crack, disjoint, or scratch on the filament (heating tube). If any,
contact your authorized technical service or seller.
- Do not use your ECONAT C-15 heater together with another appliance plugged to the
same multiple sockets or connected to the same breaker.
- Use your appliance with an adequately earthed plug.
- The earthed plug must fall outside the heating field and hot surface.
- The earthed plug must be installed at a level above the heater.
- The power cord must not be left on or around the frame of your ECONAT C-15 appliance.
- Unplug your appliance when you don't operate it for a long term or will conduct cleaning
or maintenance.
- The heater glass has to be changed at the damage.
- It has to be notified that the mounting in the bath must be so that the persons in the bath
can not reach the controls.
- It has to be notified that the product has to be installed at a dry location and may not be
wet.