8
Charge,
discharge, cycle
or monitor a
pack
1. Apply power and select power source (see above).
2. Connect pack.
3. Press
INC
or
DEC
to select desired User Preset, then press
ENTER
.
4. For each question, press
INC
or
DEC
to select correct answer, then press
ENTER
.
5.
CHECKING PACK
indicates PowerLab 6 is attempting to detect attached
pack.
6.
Screen displays preset’s chemistry. If this matches pack’s chemistry, press
ENTER
to start. (If they don’t match, just wait for the next prompt, then press
ENTER
to return to the User Preset menu.)
7. During the operation:
Press
INC
or
DEC
to view data.
Press
ENTER
to change charge current.
Press and hold
ENTER
to stop the operation.
8.
“Beep beep beep” indicates the operation is complete. Display shows
elapsed time. Press
INC
/
DEC
to review data. Operation is complete, but
“session” remains open so you can review collected data. Press and hold
ENTER
to terminate session (this erases session data).
9. Disconnect pack.
10. Press
ENTER
to return to User Preset menu.
Charge packs in
parallel
To ensure safety, only use REVOLECTRIX Safe Parallel Adapters and stackable
safety banana plugs when charging/discharging/cycling packs in parallel.
Connect up to 9 batteries of same chemistry, cell count and capacity in parallel
by stacking banana plugs. Charge as above, but enter number of packs at
Parallel Packs?
question (e.g., 2P, 3P, 4P). PowerLab 6 multiplies
preset’s
current setting
by the number of “P” selected.
*Assumes
Choose Power Source at Startup
is enabled in the CCS.