wing.
STABILIZER & ELEVATOR
Place the stabilizer and elevator on a flat surface Cut a straight angle along the hinge
area of the elevator and horizontal stabilizer. On the bottom side of the elevator is
mark 15 mm from the center point; this is where the elevator control horn will be
affixed. Di the same for the rudder hinge area. The place a thin line of Foam Tac glue
along the contact point of the Stab and the Elevator , make contact and pull away
about ¼ inch a few times to activate the glue then press together and let dry for 15
minutes. Do the same for the rudder. In the picture optional hinges are shown.
FUSELAGE
On the front of the fuselage you will attach with glue the engine firewall mount..
NOTE*The CG of the model is 3” from the wing leading edge.
With the CG in mind, Mount the battery on the right side as shown. Use Velcro on
the fuse and battery and in addition a strap to firmly hold the battery in place. Cut a
slot and glue in Battery strap.
Mark details on the fuselage for the elevator and rudder servo. Cut the hole for the
