9
5.4 D/R
ST.D / R is for servo travel adjustment, which can be multiplexed as CH2 (throttle), CH3, CH4 servo travel
adjustment, refer to [5.5 Mode Switch] for multiplex switching mode;
Adjustment range: 0-120%(the default is 100%), the step is 5%.
ST.D / R +: Increases servo travel.
ST.D / R -: Decreases servo travel.
LED Indicator
:
• When using the trim keys the G.LED will flash slowly on short presses and quickly on long presses.
• When the ratio value is at both ends (0/120%), the
ST.D / R button
is at its maximum and as such G.LED
will not flash(if the ratio value has been adjusted to 120%, then press
ST.D/R+
key is invalid and G.LED has
Instructions)
5.5 Mode switching
This function is for reusing the ST.TRIM and ST.D / R buttons for different channels (Refer to [5.3 Trims] and [5.4 D/R).
Function settings
:
Under normal power-on, quickly press the Bind button twice (within 1 second) to cycle through modes 1, 2, 3, and
4. The default setting when powering on is mode 1.
Mode 1: G.LED flashes slowly once, ST.TRIM is CH1 trim adjustment, ST.D / R is servo travel adjustment.
Mode 2: G.LED flashes twice slowly, ST.TRIM is CH1 trim adjustment, ST.D / R is CH2 servo travel adjustment.
Mode 3: G.LED flashes three times slowly, ST.TRIM is CH3 trim adjustment, ST.D / R is CH3 servo travel adjustment.
Mode 4: G.LED flashes slowly four times, ST.TRIM is CH4 trim adjustment, ST.D / R is CH4 servo travel adjustment.
This function dictates what the receiver will do in the event that it loses signal from the transmitter, this includes
servo position etc.
Function settings
:
1.
Turn on the transmitter and make sure it is connected to the receiver.
2.
Hold the control surface at the desired failsafe position.
3.
Press and hold the bind button for 3 seconds, if the G.LED starts flashes for 2 seconds, indicating that the
settings are successful.
Note: The fail-safe function has not set at the factory by default. If no failsafe setting has been set, then the
receiver will maintain the output of the last signal when the signal is lost.
5.6 Failsafe
