Website
41
7.4.7 Hardware
Voltage
"Battery meter range" Set the voltage test range of the transmitter
battery. The default value is 3.5V-4.2V.
"Battery calibration" Calibrate the voltage detection value of the
transmitter battery. The detection value of the transmitter may differ
from the battery voltage. You can calibrate it by using this function.
"Check RTC voltage" Set whether to enable the detection of time driven
battery voltage.
"ADC fliter"
(To be updated...)
Internal RF
"Mode" Select whether to enable the internal RF in this function. When
you set it to "OFF", the "Internal RF" function is disabled.
External RF
"Sample Mode"
(To be updated...)
Serial Port
"USB-VCP"
(To be updated...)
"=( Replace)" The student control command completely replaces the
trainer control command in this channel.
"+(Add)" The trainer control command and the student control
commands are added together in this channel.
"OFF" The channel will not be controlled by student control.
Calibration
It is used to calibrate the stick deviation between the trainer control and
the student control. By using this function, you can put all the sticks of
the trainer control and the student control in the middle position. To
complete this, click the "Calibrate" button.
1.
The process of using the trainer function:"Model Settings" -- "Trainer"
-- "Mode": Select the appropriate connection mode for trainer control
and student control.
2.
"Model Settings" -- "Special function": Enable the trainer function and
assign the trainer function switch.
3.
"Radio Settings"--"Trainer": Set the relevant input and output
parameters for trainer control and student control.
