Website
36
Elysium
EL18
Reset
Select the function to be reset, such as "Timer 1", "Timer 2", etc.
Enable
Set the special function to take effect.
7.3.23 Telemetry
Set the relevant functions for RSSI signal strength, sensor telemetry
data and altitude change rate. The transfer-back function of the EdgeTX
is very powerful. It can connect multiple sensors of the same type. This
function can be used to edit the functions of the sensor. In EdgeTX, all
telemetry values can be used as a single sensor data for editing related
functions.
RSSI
"Low alarm" and "Critical alarm" Set the alarm threshold value of the
signal strength.
"Disable telemetry alarm" Set whether to enable RSSI signal strength
alarm.
Sensor
Display the current sensor number, the name of the transfer-back
telemetry data, detection digit, and ID.
The following is the sensor telemetry data in the connection to the Flysky
receiver:
"A1" Display the current input operating voltage of the receiver.
"RSSI" Display the current signal strength value.
"Tmp1" Display the current temperature sensor value.
"Alt" Display the current altitude value of the barometric pressure
sensor.
"Pres" Display the current barometric pressure value of the barometric
pressure sensor.
Click the sensor value and select "Edit" to edit the function of the sensor.
"Name"
(To be updated...)
"Type"
(To be updated...)
"Custom"
(To be updated...)
"ID"
(To be updated...)
"Opration"
(To be updated...)
"Unit" Select the appropriate calculation unit for the sensors. For
example, V voltage, A current, m length or height, mah battery capacity,
etc.
"Accuracy" "0.--": Display the accuracy to a single digit; "0.0-" shows the
accuracy to one decimal point; "0.00" shows the accuracy to two decimal
points.
