8
Check for damaged or worn parts
Please contact your local Electrolux
Outdoor Products Approved Service
Centre for further information or for re-
placement of damaged or worn parts.
S
ON/OFF
Switch -- Ensure switch
functions properly by moving the
switch to the
OFF
position. Make
sure motor stops; then restart mo-
tor and continue.
S
Inlet Cover -- Discontinue use of
unit if inlet cover fails to latch prop-
erly or if it is damaged in any way.
After each use
Inspect and clean unit and labels
Stop unit and disconnect the mains
electricity supply.
S
After each use, inspect complete
unit for loose or damaged parts.
Clean the unit using a damp cloth
with a mild detergent.
S
Wipe off unit with a clean dry cloth.
Clean collection bag
IMPORTANT:
THE COLLECTION BAG
MUST BE PROPERLY EMPTIED.
D
You must properly empty and main-
tain the collection bag to avoid dete-
rioration and obstruction of air flow.
D
Remove the collection bag from
the unit and empty after each use.
Do not store bag without emptying
the bag of all contents (grass,
leaves, etc.).
D
Wash the bag once a year. Remove
the bag from the blower and turn the
bag inside out. Wash the bag with a
water hose. Allow the bag to hang
and dry completely before you reuse
the bag.
Service
WARNING:
All internal or electri-
cal service
MUST
be performed by your
local Electrolux Outdoor Products Ap-
proved Service Centre.
How to remove an object from the
air intake
WARNING:
Stop the unit and dis-
connect the mains electricity supply be-
fore opening the inlet cover. The motor
must be stopped and the impeller
blades no longer turning to avoid seri-
ous injury from the rotating blades.
1. While holding the inlet cover open,
remove the vacuum tubes. The inlet
cover must be held open through all
remaining steps.
2. Carefully reach into the vacuum
opening and clear out the air intake
area. Clear all debris from impeller.
3. Inspect the impeller for cracks. If
cracked or damaged, do not use the
unit. Have parts replaced by your lo-
cal Electrolux Outdoor Products Ap-
proved Service Centre. Do not at-
tempt to replace them yourself.
Storage
WARNING:
Perform the following
steps after each use:
S
Stop the unit and disconnect the
mains electricity supply.
S
Allow motor to cool before storing or
transporting.
S
Store unit with all guards in place.
Position unit so that any sharp object
cannot accidentally cause injury.
S
Store unit unplugged, well out of the
reach of children.
Seasonal storage
Prepare unit for storage at the end of
the season or if it will not be used for
30 days or more.
If your blower is to be stored for a peri-
od of time:
S
Stop the unit and disconnect the
mains electricity supply
S
Clean the entire unit before lengthy
storage.
S
Open inlet cover and clean any dirt,
grass, or debris that has collected.
Inspect the blower and all tubes.
Close and make sure the cover is
latched.
S
Clean air vents and air inlet of debris.
S
Store your unit in a well ventilated
area and covered, if possible, to
prevent dust and dirt accumulation.
Do not cover with plastic. Plastic
cannot breathe and may cause
condensation and eventual rust or
corrosion.
S
Check entire unit for loose screws.
Replace any damaged, worn, or
broken parts.
