Flymo Power Vac 3000, Руководство оператора

Страница: 7 / 12

4. MAINTENANCE
To clean the product [ Fig. M1 / M2 ]:
DANGER! Electric shock!
Risk of injury and risk of damage to the
product.
v
Do not clean the product with water or with a
water jet (in particular high-pressure water jet).
The airflow slots must always be clean.
3. OPERATION
Lower speeds during vacuum use could allow debris to
build up, stall the motor and cause product failure.
Work positions:
Blow mode [ Fig. O2 ]:
Use your product as a blower for sweeping debris or grass
clippings from driveways, sidewalks, patios, etc. Also, for
blowing grass clippings, straw, or leaves into piles, or
removing debris from corners, around joints, or between
bricks.
Direct air flow by directing the blower tube down or to one
side.
Always work away from solid objects such as walks, large
stones, vehicles, and fences.
Clean corners by starting in corners and moving outward.
This will help prevent an accumulation of debris which
could fly into your face. Be careful when working near
plants. The force of the air could damage tender plants.
Vacuum mode [ Fig. O3 ]:
Use your product as a vacuum to pick up dry material such
as leaves, grass, small twigs, and bits of paper.
For best results during vacuum use, operate your unit at
high speed.
Move slowly back and forth over the material as you vacu-
um. Avoid forcing the unit into a pile of debris as this can
clog the unit.
Keep the vacuum tube about an inch above the ground for
best results.
WARNING: If the product becomes clogged, stop the
unit and unplug the extension cord. Wait until the
impeller has completely stopped turning, then
remove the vacuum tubes. Carefully reach into the
vacuum opening and clear out the clogged debris.
This will reduce possible personal injury from the impeller.
1. Remove the tubes and the collection bag.
2. Clean the airflow slots
(16)
and the air intake / outtake
area
(17)
with a soft brush (do not use a screwdriver).
Remove all debris from the impeller.
3. Clean the blower head with a damp cloth.
4. Clean the tubes. Remove all debris from the tubes.
5. Turn the collection bag inside out and clean it with water.
5. STORAGE
To put into storage:
The product must be stowed away from children.
1. Disconnect the mains cable.
2. Clean the product.
3. Stow the product in a dry area where it has protection
from frost (Do not stow a dirty collection bag).
Disposal:
(in accordance with RL2012/19/EC)
The product must not be added to usual
household waste. Refer to local environmental
laws for discarding.
v
Important: Make sure that the product is discarded
through your municipal recycling collection centre.
6. TROUBLESHOOTING
WARNING! Risk of physical injury!
Cut injury when the impeller turns or the
product starts accidentally.
v
Wait for the impeller to stop, disconnect the
product from the mains and use gloves before
you do maintenance.
Problem Possible Causes Remedy
Product does not start Blower tube, elbow tube or vacuum
tube is not assembled correctly.
v
Assemble the tubes correctly
(see 2. ASSEMBLY).
Collection bag is full.
v
Empty the collection bag.
Extension cable is disconnected.
v
Connect the extension cable.
Mechanical failure.
v
Contact your authorized service
dealer.
Product vibrates abnormally Debris in air intake area.
v
Clean the product. Remove any
debris.
Mechanical failure.
v
Contact your authorized service
dealer.
For any other malfunctions please contact the Husqvarna UK Ltd. Customer Service.
Repairs must only be done by Husqvarna UK Ltd. service departments or specialist dealers
approved by FLYMO.
7
EN
PV3000V-20.960.01.indd 7 25.04.17 08:36