H
G
1
Starting
• The switchbox is provided with a lock-off button
(G1) to prevent accidental starting.
5. Press and hold the lock-off button (G) on the
switchbox, then squeeze one of the Start/Stop
levers towards the upper handle (H).
6. Continue to squeeze the start/stop lever towards
the upper handle and release the lock-off button.
7. When the product has reached full speed gently
lower it onto the lawn.
• NOTE There are two start/stop levers fitted. Either
one can be used for starting the product.
• IMPORTANT Do not use the start/stop levers
intermittently
Stopping
1. To prevent a ring being cut in your lawn, tilt your
product slightly (F).
2. Release the pressure on the Start/Stop lever.
Adjusting the Cutting Height
L
M
1
2
3
3
2
1
HIGHEST
This symbol visible
LOWEST
This symbol visible
J
K
•
THERE ARE 2 CUTTING HEIGHTS (J & K)
•
Height of cut is adjusted by turning over the cutting
head.
•
Disconnect from the mains electricity supply and
wait until the cutting head has stopped rotating.
Turn your product upside down.
•
To Remove the Cutting Head and Fan (L)
Hold the fan firmly and twist the cutting head anti-
clockwise as illustrated. Hold the cutting head in
the centre and remove as illustrated. Hold fan in the
centre and remove as illustrated.
•
Inspect for damage and clean as necessary before
replacing the fan and the cutting head.
•
To Refit the Fan and the Cutting Head (M)
Replace the fan as illustrated. Replace the cutting
head, adjusting the height of cut as required. Hold
the fan firmly and twist the cutting head clockwise,
as illustrated.
•
IMPORTANT
ENSURE FAN AND CUTTING HEAD ARE
CORRECTLY LOCATED
