SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD
Http://w ww.carymart.com E-Mail: [email protected]
Setting control mode Latched: Connect Jumper-1 and Jumper-2.
Control mode Latched: Press -> On, other relays Off; Press another button -> Off.
Press button 1: Turn on the relay (connect B and C, disconnect A and B)
Press button 2: Turn off the relay (disconnect B and C, connect A and B)
If you set delay time, such as 10 seconds:
Press button 1: Turn on the relay (connect B and C, disconnect A and B)
After 10 seconds, Turn off the relay automatically (disconnect B and C, connect A and B). Or press button 2 w ithin 10 seconds: Turn off the relay
immediately.
Delay time setting function:
Press the setting button, the LED off, that means enter into the delay time setting mode.
Then you can set delay time through pressing the learn button. Press the learn button, LED w ill flash once, that means the delay time increase 1
seconds, if you w ant to delay 30 seconds, you need to press the learn button w ith 30 times.
You can set longest delay time to 99 seconds.
Press the setting button again, the delay time w hat you have set w ill be preserved forever even if you turn off pow er. After the delay time is
preserved by the system, LED w ill flash 3 times, the system w ill quit the delay time setting mode.
For example, w hen you use this receiver to control one lamp, and you already set 30 seconds delay time, you can press button 1 to turn on the
lamp, and the lamp w ill turn off automatically after 30 seconds.
If you don’t need the delay function, you should clear the delay time.
Clear delay time:
If you don’t want to set the delay time, you can operate as follow ing:
Press the setting button and enter into the delay time setting mode, the delay time w hat you have set w ill be cleared automat ically.
Press the setting button again, LED w ill flash 3 times, the system w ill quit the delay time setting mode.
Note:
We have learned remote control to the receiver. If you don’t want the receiver to work with the remote control, you can delete all codes of remote
controls, w hich are stored in the receiver.
Operation: Press and hold the learn button of receiver until LED begin flashes slow ly; release the button, LED keeps slow flash. That means all
stored codes have been deleted successfully.
Learning the button of remote control:
1) Press the learn button of receiver, LED off. The receiver enters into status of LEARNING.
2) Press any one button on remote control. If LED flashes 3 times and turns off, it means learning is successful.
3) When receiver is in the status of LEARNING, you should learn the remote control w ithin 10 seconds, or the receiver w ill quit the status of
LEARNING after 10 seconds.
4) The receiver can learn 16 remote controls w ith different codes.
Interior Analogue Circuit
Application: For DC12V motor or lamp
DC0~28V/ AC110~240V
Application Circui t
Power supply
A, B=Norm ally Closed; B, C=Norm ally Open.
Lamp
Relay
_
+
A
B
C
Relay
_
+
A
B
C
Learn Button
LED
Antenna
R
F
m
o
d
u
le
LED
Setting Button
2
1
3
Jumper
Jumper
3
2
1
Learn Button
Setting Button
Antenna
R
F
m
o
d
u
le
M
_
+
Power supply
Motor
+
