FLYGT MAS 711, Инструкция по установке и эксплуатации

Страница: 35 / 150

Installation, Wiring, Large Pumps, SubCab 24–lead Sensor Cable
Wiring, Large Pumps, SubCab 24–lead Sensor Cable
NOTE!
The wires of the sensor cable shall be connected to the cabinet connection block.
The numbers of the cabinet connection block will differ from the numbers of the base
unit terminal block.
Wire
Connection
This table shows the connection of the wires for a SubCab 24-lead sensor cable:
Sensor/Component Sensor cable, no. Base unit terminal
block, no.
1 13
FLS — Leakage in stator housing 1)
2 14
3 8
Pt100 — Temperature measurement,
main bearing
4 4
5 1
Thermal switches — Temperature
guard stator windings
6 2
7 15
FLS — Leakage in junction box 1)
(2) (14)
8 3
Pt100 — Temperature measurement,
stator winding ph 1
(4) (4)
Pump memory:
• RS–485 B 2) 9 38
• RS-485 A 2) 10 37
• Supply, ground 11 36
• Supply, 12V + 12 35
13 5
Pt100 — Temperature measurement,
stator winding ph 2
14 7
15 6
Pt100 — Temperature measurement,
stator winding ph 3
16 7
17 9
Pt100 — Temperature measurement,
support bearing
18 10
19 17
CLS — Leakage in oil housing
20 16
21 18
VIS 10 — Vibration sensor
22 19
(Screen)
If applicable, attach
screen to ground
terminals in the
• pump top
and
• electrical cabinet.
35