FLYGT MAS 711, Инструкция по установке и эксплуатации

Страница: 28 / 150

Installation, Wiring, Supply and Additional Inputs/Outputs
Wiring
diagrams
Use the following wiring diagrams when connecting the unit:
• The wiring diagram of the cabinet.
• The applicable
Wiring sections below.
Instruction
Follow the steps below to connect the unit:
Step Action
1 Check which number on the cabinet connection block that is connected to
which number on the base unit terminal block. This information is found in the
wiring diagram of the cabinet.
Note! The numbers of the base unit terminal block do not have to match the
numbers of the cabinet connection block.
2 Connect the wires to the base unit according to the following sections below:
• Wiring, Supply and Additional Inputs/Outputs
• Wiring, Modbus communication
• Wiring, Relay Outputs
3 Identify the applicable sensor con
fi
guration and connect the sensor cable to
the cabinet connection block according to the applicable section below:
• Wiring, Large Pumps, SubCab 12–lead Sensor Cable
• Wiring, Large Pumps, SubCab 24–lead Sensor Cable
• Wiring, Midrange Pumps, SubCab 12–lead Sensor Cable, Alternative 1
• Wiring, Midrange Pumps, SubCab 12–lead Sensor Cable, Alternative 2
• Wiring, Midrange Pumps, SubCab 25–lead Sensor Cable
4 Turn on the voltage to the unit.
Wiring, Supply and Additional Inputs/Outputs
Illustration
This is an illustration of section 1 of the base unit terminal block:
26 25 24 23 22 21 20
–
/Gnd
+ +
Gnd
28