FLYGT MAS 711, Инструкция по установке и эксплуатации

Страница: 139 / 150

Operation, Copy Data To/From Pump Memory
Copy Data To/From Pump Memory
Topics in this
Section
This section contains the following topics:
• Copy Data To/From Pump Memory Using the Web Tool
• Copy Data To/From Pump Memory Using the Operator Panel
Data Copied
During Pump
Memory
Synchronization
The following data is automatically copied from MAS to the pump memory every 2 hours:
• Pump data plate information
• Alarm settings
• Start and stop registrations
• Histograms
• Service log
The same data that is copied during the automatic synchronization can be copied manually
to and from the pump memory. See instructions below.
Copy Data To/From Pump Memory Using the Web Tool
Copy All Data
From Pump
Memory to
MAS
At
fi
rst installation, the base unit should be updated with the contents of the pump memory
to upload factory settings of sensors and associated parameters (alarm limits, reset
options, etc.). If any changes are made to the pump memory during service, the new
data should be uploaded to the base unit.
Follow these steps to copy all data from pump memory to MAS:
Step Action Result
1 Click Setup — Pump info — Pump memory.
2 In the Manual pump memory synchronization
fi
eld, select Copy all from pump memory to
MAS and click Copy.
“Do you want to perform the
synchronization?” is displayed.
3 Click OK. “Synchronization OK!” con
fi
rms
when the synchronization is
performed.
Copy All Data
From MAS to
Pump Memory
It is possible to copy any recent changes or latest measurements immediately to the
pump memory, for example before service, to make sure the latest data is stored in the
pump memory before removing the pump.
Follow these steps to copy all data from MAS to pump memory:
Step Action Result
1 Click Setup — Pump info — Pump memory.
139