Flybox APR1, Руководство пользователя

Страница: 43 / 52

FLYBOX
General Suggestions
REV 1.0
43
®
APR1
-
User Manual,
Safety Instructions and Warning Booklet
5.3 Use in ADV+
(Advanced Plus mode)
In Advanced Plus mode, the APR1 regulator will
automatically set the engine revs following the Speed/
RPM curve and also to the MAP/RPM curve set by your
installer.
After setting the ADV+ control mode, see chapter 4.3.1,
you can follow the advice below if you want to use APR1
in this automatic mode.
At start-up, the instrument will automatically set the target
rpm to the maximum value set by your installer, e.g. 5700
or 5800 in case of Rotax or another RPM in case of a
different engine.
Before takeoff, always do the Propeller test in automatic
mode as expected and explained in chapter 4.1.
This is to check that the APR1-propeller system is working
correctly and if something goes wrong,
do not take off but
check what the problem might be and if necessary call
your technician.
When the the Propeller Test is finished, check that the
green idle pitch light is lit and that the target RPM on the
display is the maximum RPM for takeoff.
During the takeoff run, in addition to checking the
increasing aircraft speed, it is mandatory to check if the
motor is giving the target RPM for takeoff. Remember that
the target RPM shown on APR1 are not the engine RPM.
The engine RPM must be checked on the aircraft
tachometer and not on the
APR1 screen.