使用您的PHANTOM 3 Advanced
3. 检查电量
请分别短按一次遥控器和智能飞行电池的电源开关以检查电量。
首次使用智能飞行电池，请务必充满电。
短按一次、再长按2秒遥控器电源开关可开启遥控器（重复本操作可关闭遥控器）。
短按一次、再长按2秒智能飞行电池开关可开启智能飞行电池（重复本操作可关闭智能飞行电池）。
●
推荐在平板设备上使用DJI GO App以获得最佳的体验。DJI GO App要求使用iOS 8.0及以上系统和Android 4.1.2及以上系统。
1. 下载 DJI GO App
安装
DJI GO
App，请在软件商店或扫描下方二维码下载。
或用移动设备访问以下网址：
http://m.dji.net/djigo
2. 观看入门教学视频
扫描二维码观看
扫描二维码下载安装
低
高
电量
使用Phantom 3 Advanced 之前，请 在 DJI GO App 或者 DJI 官方网站产品页面完整观看教学视频与下载阅读
《Phantom 3 Advanced 用户手册》，并仔细阅读以下包装内文档：《Phantom 3 Advanced 快速入门指南》、
《Phantom 3 免责声明和安全操作指引》、《Phantom 3 智能飞行电池安全使用指引》和《物品清单》。
4. 充 电
●
请使用 DJI 官方提供的充电器充电。充电前需将智能飞行电池取出。
●
连接充电器到交流电源（100~240 V，50/60 Hz；如需要请使用电源转换插头）。
●
智能飞行电池、遥控器开启或关闭的状态下均可充电。建议在关闭状态下充电。
●
在关闭状态下充电时，智能飞行电池与遥控器指示灯全部熄灭表示电已充满。
B
A
B
A
取出智能飞行电池
低
高
电量
请在 DJI GO App 或访问DJI官方网站观看。
http://www.dji.com/cn/product/phantom-3/video
www.dji.com
ADVANCED
PHANTOM
3
bout the use of fully manual
mode.
When the helicopter is flying in the air, switch from
mode switch to
mode, the helicopter will
fall down uickly. If you are a novice, it is very dangerous to operate this function, and the helicopter
will crash. xperienced pilots can uickly and manually increase pitch control after switching
to
mode.
●
nlock take off in
mode take mode as an example
1
ial the
motor run
s
witch
to stop
position
, dial
the
mode s
witch
to
position,
ove the helicopter to the outdoor open
environment without trees and buildings.
ower on, and the
H1
flight control light is
solid
blu
e.
nlock as shown in the figure and hold
for about seconds until the flight control
light
is
flash
ing blue
.
uring the blue
light is
flashing, ial
motor
switch
stick to run
position
,and the hel
icopter
motor
will run
. ush throttle
stick upwards
to take
off.
. Home ode
If you need to use the home mode one key to return, low power return , please make sure that the
satellite signal is good before take off, and there are no buildings or trees around the take off point that
hinder the return.
●
mart return
ial the s
witch
to H
,the helicopter return automatically. Then dial to
mode to terminate the
return flight.
•
ow power return when the power system judges that the current power is low, it will auto return
and land. lease ensure that the current distance of the helicopter conforms to the range of the
helicopter s remaining power.
•
When returning with low power, the helicopter will auto rise up to 1 meters, and then return,
which isn t controlled by the operator. If there are obstacles trees or buildings on the way back,
the auto flight needs to be terminated
●
Ways to stop low power
•
If you want to stop the low power return, please
flick the switch
to H
, and then
flick the switch
to
. You can manually control the helicopter after landing and manually turn off the motor.
uring this period, the helicopter will not return with low power until the helicopter is powered off.