FS-X14S
接收机 Receiver
http://www.flysky-cn.com
Copyright ©2020 Flysky Technology co., ltd
1. First put the transmitter into bind mode (see the transmitter's user manual for instructions on how to activate bind mode.)
2. Press receiver's bind key and connect the receiver to power at the same time. The receiver's green LED will start to flash quickly
indicating that it has entered bind mode.
When the receiver's green LED stops flashing the transmitter and receiver have successfully bound.
When the receiver's red LED flash slowy indicating losing signal.
If there is a critical hardware error the LED will remain red.
3. Check to make sure that the transmitter and receiver are working as expected, if there are any issues or unexpected operation
follow the steps above to bind again.
对码
Binding
注意事项：
• 使用前必须确保本产品与模型安装正确，否则可能导致模型发生严重损坏。
• 关闭时，请务必先关闭接收机电源，然后关闭发射机。如果关闭发射机电源时接收机仍然在工作，将有可能导致遥控设备失控
或者引擎继续工作而引发事故。
• 确保接收机安装在远离电机，电子调速器或电子噪声过多的区域。
• 接收机天线需远离导电材料，例如金属棒和碳物质。为了避免影响正常工作，请确保接收机天线和导电材料之间至少有 1 厘米
以上的距离。
• 准备过程中，请勿连接接收机电源，避免造成不必要的损失。
Attention:
• Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury.
• Make sure the receiver's battery is disconnected before turning off the transmitter, failure to do so may lead to unintended
operation or loss of control.
• Make sure the receiver is mounted away from motors, electronic speed controllers or any device that emits excessive electrical
noise.
• Keep the receiver's antenna at least 1cm away from conductive materials such as carbon or metal.
• Do not power on the receiver during the setup process to prevent loss of control.
失控保护
Failsafe
此功能用于当接收机无法正常收到发射机的信号时，保护
模型和操作人员的安全。
• 若发射机未设置失控保护通道值输出，接收机在进入失
控保护状态后 S.BUS 保持最后输出，PPM 无输出；若
发射机设置了失控保护，设置后各通道依照发射机设置
的参数输出。具体操作详见各发射机失控保护章节。
This function protects your vehicle by preventing unexpected
behaviors in case of signal lost.
• If the transmitter is not set with fail-safe channel value output,
S.BUS keeps the final output after the receiver enters fail-safe
state, and PPM has no output; If the transmitter is set with
fail-safe mode, each channel will be output according to the
parameters set by the transmitter. Please refer to the failsafe
section of each transmitter for specific operation.
