FS-iA8X
接收机 Receiver
http://www.flysky-cn.com
Copyright ©2020Flysky Technology co., ltd
注意事项：
•
使用前必须确保本产品与模型安装正确，否则可能导致模型发生严重损坏。
•
关闭时，请务必先关闭接收机电源，然后关闭发射机。如果关闭发射机电源时接收机仍然在工作，将有可能导致遥控设备
失控或者引擎继续工作而引发事故。
•
确保接收机安装在远离电机，电子调速器或电子噪声过多的区域。
•
接收机天线需远离导电材料，例如金属棒和碳物质。为了避免影响正常工作，请确保接收机天线和导电材料之间至少有1厘
米以上的距离。
•
准备过程中，请勿连接接收机电源，避免造成不必要的损失。
Attention:
•
Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury.
•
Make sure the receiver's battery is disconnected before turning off the transmitter, failure to do so may lead to
unintended operation or loss of control.
•
Make sure the receiver is mounted away from motors, electronic speed controllers or any device that emits excessive
electrical noise.
•
Keep the receiver's antenna at least 1cm away from conductive materials such as carbon or metal.
•
Do not power on the receiver during the setup process to prevent loss of control.
失控保护功能用于在接收机失去信号不受控制后，保护
模型及人员安全。
•
若发射机未设置失控保护通道值输出，接收机在进
入失控状态后PPM无输出，S.BUS和i-BUS保持最后
输出；若发射机设置了失控保护，则按照发射机通
道设置输出。
失控保护
Failsafe
This function protects your vehicle by preventing unexpected behaviors
in case of signal lost
.
•
If the transmitter is not set with failsafe channel value output,
the PPM has no output after the receiver enters out-of-control
state, and the S.BUS and i-BUS keep the final output; If the
transmitter is set with failsafe mode, the output shall be set
according to the transmitter channel. Please refer to the fail-
safe section of each transmitter for specific operation.
1. First put the transmitter into bind mode (see the transmitter's user manual for instructions on how to activate bind mode.)
2. Connect the receiver to power, the receiver's LED will start to flash indicating that it has entered bind mode.
3. When the receiver's LED stops flashing the transmitter and receiver have successfully bound.
4. Check to make sure that the transmitter and receiver are working as expected, if there are any issues or unexpected operation
follow the steps above to bind again.
对码
Binding
