Fly Sky FS-i4X, Инструкция по эксплуатации, Страница: 13 / 25

12
Digital proportional radio control system
4.3 Binding
The transmitter and receiver have been pre-bound before delivery. If you are using another transmitter or
receiver, follow the steps below to bind the transmitter and receiver:
1. Connect the supplied bind cable to the
BAT port on the receiver.
2. Insert power into any other port.
3. Hold the bind key while powering on the transmitter to enter bind mode.
• When the receiver and transmitter have bound the red LED will stop flashing.
4. Remove the power and bind cable from the receiver. Then connect the power cable to the BAT port.
5. Turn on the transmitter.
6. Check the servos' operation. If anything does not work as expected, restart this procedure from the
beginning.
4.4 Pre-use Check
Before operation, perform the following steps to check the system:
1. Check to make sure that all servos and motors are working as expected.
2. Check operating distance: one operator holds the transmitter, and another one moves the model
away from the transmitter. Check the model and mark the distance from where the model starts to
lose control.
Danger • Stop operation if any abnormal activity is observed.
Danger • Make sure the model does not go out of range.
Attention • Sources of interference may affect signal quality.
4.5 Changing Stick Modes
There are two sticks on the transmitter and two preset modes for the functions of the sticks. Usually the
stick with the self centring feature on both axes will be mapped to the Elevator, while the other to the
Throttle.
The functions of the sticks in respective modes are shown below:
Mode 1 Mode 2
8[JJKX 'ORKXUT
+RK\
GZUX
:N
XU
ZZR
K
8[JJKX 'ORKXUT
:N
XU
ZZR
K
+RK\
GZUX
You can switch the stick modes to suit your operation habit. To switch the sticks:
1. Take the battery out from the transmitter. Loosen the four screws that hold the rear cover shown in
green on page 13.
2. Carefully take the back off the transmitter and disconnect the cables connected to it.
3. Unscrew the screws around the gimbals, marked in green in the picture on page 13.
4.2