GOLD 95/115/130 OWNER’S MANUAL VER 10
©
Copyright by
FLY
Products
srl
Page
10
This completes the harness mounting Double check your work to ensure that everything is OK
Drive
Before installing
the propeller,
make sure that the
reduction (pinion)
is the right one for
your prop
Drive 1:2,4
For wooden prop or
props with a
maximum diameter
of 100 cm
Drive 1:2,6
For carbon fiber
propellers 2 blade or
3 blade.
Prop Mounting
NOTE
: Here is some terminology we’ll use in this section
The “front” is the direction the pilot faces while flying, the “rear” is the opposite direction
The “front” of the prop can be identified by the thick side of the prop blades (leading edge)
The “rear” side of the prop can be identified by the thin side of the prop blades (trailing edge) as the
upper blade section shown in fig 17
The “rear prop flange” is the one that is most rearward when the prop is mounted
The “front prop flange” is the one that is mounted on the reduction drive
