installation
PAGE 2 of 4
Install-View | 2020-03
All rights reserved. © Fluxwerx Illumination 2020 604.549.9379 | fl uxwerx.com
Due to continuous product improvements, specifi cations and dimensions are subject to change without notice. Certain options have
limited compatibility with some other product selections. Consult www.fl uxwerx.com for most current technical information.
Refer to Row Confi guration Document
1. Lift fi rst fi xture section (or individual fi xture if stand-alone) into place,
supporting it under the lower rail (NOT top rail).
2. Insert the aircraft cables into both ends of the fi xture mounts.
3. Adjust height and level the fi xture section. The aircraft cable gripper is
released by pressing down on the inner tube.
If stand-alone fi xture, go to step #8.
For Joining Ends: Bend cable up and cut cable near exit point so cable does
not protrude out.
Trim aircraft cable to length (drop height from ceiling to top of fi xture
+ 1.5") with a sharp side cutter, minimizing any frayed ends. Fixture can
accept a max. length of up to 2" of aircraft cable. Aircraft cable gripping
mechanism needs min. 1" aircraft cable inserted.
Lay the fi xture sections out to ensure the correct sections with ends and
joints are supplied. Note that runs will have a Non-Power suspension
point located one point in from the end of the run. Ensure fi xture sections
are laid out to match the Power suspension points that were prepared on
the ceiling.
1. Lift the next fi xture section into position, supporting it underneath.
Insert an aircraft cable into the non-joining end to retain it, then slide
the joiner end into the previous fi xture and press them together.
2. Level the end of the fi xture by adjusting the aircraft cable in the gripper.
2
TRIM AIRCRAFT CABLE
3
LAY OUT LUMINAIRES
5
CUT AIRCRAFT CABLE AT JOIN
4
LIFT INTO PO LEVEL
6
JOIN FI LEVEL
DROP 1.5"
NOTE:
1. For Drywall and Surface ceiling types, feed the aircraft cable through
the canopy cover and threaded sleeve before inserting the cable into
the fi xture mount.
2. Leave the protective bag on the fi xture during installation.
view suspended