Basic Operation
1
Select the dial signaling required (touch tone or pulse)
with the TONE/PULSE switch.
2
Set the TALK/MONITOR switch to M and connect the
test set to the line. Listen to verify the line is idle. The
test set's high impedance prevents disruption of data
traffic when connected to a line in monitor mode.
3
Set the TALK/MONITOR switch to T, and verify that
dial tone is received.
4
Dial the number to be called. To terminate the call
during or after dialing, set the TALK/MONITOR switch
to M.
Last Number Redialed
In Tone or Pulse mode, the last number dialed can be
redialed by pressing the LNR key after going on-hook
(MONITOR) and then back off-hook (TALK).
Note: When dialing out through a PBX, you may use the
PSE key to insert a pause before initially dialing the
number.
Storing Numbers In Memory (Auto Dialer)
1
Press STO (STORE).
2
Press the number for the desired memory location
(1-9).
3
Enter the number to be stored (18 numbers
maximum).
Note: If a pause is needed (as for a PBX), press the PSE key
where a pause is necessary.
4
Press STO (STORE).
5
Press the number for the desired memory location
(1-9).
Storing a Number You Are Calling
1
Connect the test set to the line and receive dial tone.
2
Dial the number.
3
Press STO (STORE).
4
Press the number for the desired memory location
(1-9).
Note: In Pulse mode, pressing STO (STORE) stops any
further digits from being outpulsed, although all digits
will be stored. Therefore, wait until all digits have been
outpulsed before pressing STO.
TS22 Amplified Speaker Mode
1
Connect the test set to the line, put the test set in
TALK (T) mode, and receive dial tone.
2
Press the SPEAKER button once for Amplified Speaker
mode at low volume. The transmitter and receiver
automatically turn off when the speaker is on to
prevent acoustic feedback.
3
Press the SPEAKER button a second and third time for
medium and high volumes.
4
Press the SPEAKER button a fourth time to turn the
speaker off and return to TALK mode.
Note: When the speaker is on, the polarity LEDs are off.
They turn back on when the speaker timer elapses or is
turned off with the SPEAKER button.
TS22A Speakerphone Mode
1
Connect the test set to the line, put the test set in
TALK (T) mode, and receive dial tone.
2
Press the SPEAKER button once for Speakerphone
mode at low volume.
3
Press the SPEAKER button a second and third time for
medium and high volumes.
4
Press the SPEAKER button a fourth time to turn the
speakerphone off and return to TALK mode.
Notes: (1) Pressing the MUTE button while in
Speakerphone mode mutes the transmit microphone for
privacy. (2) When using Speakerphone mode in noisy
environments, it may be helpful to temporarily lock the
MUTE button while listening; then unlock it to talk.
To prolong battery life, the TS22A shuts off the
speakerphone after about 5 minutes when there has been
no signal greater than -30 dBm. Speakerphone mode
must be reactivated every 5 minutes if no signal greater
than -30 dBm is detected.