PN 2322420
October 2005
©2005 Fluke Corporation. All rights reserved. Printed in China.
TS
®
22/TS
®
22A Test Set Users Card
Key
Function
STO Stores the last number dialed in memory.
(18 digits maximum; 9 locations).
PSE Places a 4-second pause between numbers being
entered into memory. The pause occurs when the
stored numbers are redialed, and is used to access
second dial tone when dialing through a PBX.
RCL Recalls a number stored in memory.
LNR Redials the last number called. This feature works in
Tone or Pulse modes.
Replacing the Monitor Speaker Battery
A 9 V alkaline battery powers the Amplified Speaker or
Speakerphone. If the battery is low, the test set will not
enable the TALK (off-hook) mode. Replace the battery if
the test set does any of the following:
• Fails to operate
• Operates intermittently
• Sounds distorted
To replace the battery
1
Remove the three screws from the battery cover.
2
Remove the battery cover.
3
Lift out the battery retainer.
4
Remove the battery from the battery boot and install
a new alkaline or lithium 9 V battery.
5
Replace the battery boot, retainer, cover, and screws.
Strain relief ring must be inside the case as shown.
Avoid pinching the battery wires.
Replacing the Belt Clip