Fluke TS 100 PRO, Руководство пользователя

Страница: 9 / 26

5
Operation
Operation
Installing Batteries
 Warning 
To avoid possible fire, electric shock or
personal injury:

To prevent unreliable test results, replace the
battery as soon as
LO bAtt
shows on the display.

Before you remove the battery door, disconnect
the test leads from the cable or circuit.

Use only four AA batteries, correctly installed, to
supply power to the tester.

Do not use the tester without the battery door
installed.

Use caution when handling batteries. Do not let
the terminals short together. Dispose of batteries
properly to ensure terminals cannot short. Disposal
may be restricted by local laws.
Note
To extend battery life, remove the batteries if
you will not use the tester for a long period.
To install the batteries:
See Figure 2.
1 Use a number 2 Phillips screwdriver to loosen the
screw on the battery door.
Note
The screw does not come out of the battery
door.
2 Remove the battery door.
3 Install the batteries. Make sure the polarity is
correct, as shown at the bottom of the battery
compartment.
4 Install the battery door and tighten the screw.
GOD02.eps
Figure 2. Installing the Batteries